Comprehensive consideration of sink rounded corner design: R-value, aesthetics, practicality and manufacturing requirements

June 19, 2024

The rounded corner design of the sink in the specific requirements, you can refer to the following points:

First, the radius of rounded corners (R value)

R value is usually used to indicate the size of the radius of the rounded corners in millimeters (mm).

In the common Kitchen Sink design, the size of the R value is usually between R10 and R25, and the design of rounded corners within this range is considered the most practical. Among them, R10 refers to a rounded corner with a corner radius of 10mm, which is closest to a right angle, but with a rounded edge transition for ease of cleaning, as well as increasing the space available in the basin.

Second, the purpose of the design

Aesthetics: rounded corners make the sink look softer and harmonize with modern home style.

Practicality: The rounded corner design is easy to clean, avoiding the problem that the right angle design is easy to accumulate dirt.

Safety: The rounded corner design reduces the potential safety hazards of sharp right angles, especially for families with children.

Third, the material and thickness

The material and thickness of the sink is also an important factor affecting its service life and performance. Stainless Steel Sink is a common choice, its thickness is generally between 0.8mm to 1.2mm, able to withstand a certain amount of concentrated load and high temperature.

Fourth, manufacturing requirements

Since the rounded corner design is more structurally complex compared to the right angle design, it requires higher precision and more complex processes in the manufacturing process. This may increase the manufacturing cost to some extent.

V. Installation and Use

When installing the sink, it is necessary to ensure a good seal between the rounded part and the countertop or other installation surface to prevent water leakage.

In the process of use, need to pay attention to avoid the use of too sharp or hard tools or objects scratching the rounded part of the sink, so as not to affect its beauty and service life.

In summary, the design of the rounded corners of the sink has specific requirements in terms of R value, design purpose, material and thickness, manufacturing requirements, as well as installation and use. When choosing and buying sinks, consumers can consider these factors comprehensively according to their needs and budget.

Author:

Mr. John

E-mail:

manager@jmmeiao.com